成人在线网站观看,精品久久久久久无码中文字幕

The preferred heating method for buildings with large space — hot water infrared radiation panel

time：2023-05-19
hits：1795次
source：正弘奧能

In the tall space building, the choice of winter heating mode is very important, in the choice of heating mode, the main consideration of human comfort, energy saving and air quality and other factors.Due to the rise of hot air, the traditional convective heating mode consumes a lot of heat in the upper part of tall buildings, and the lower work area is difficult to get enough heat, and the temperature distribution is not uniform.This not only causes the waste of energy, but also the thermal comfort is poor.


	 


	So researchers took a closer look at solar energy, found an infrared radiation technology, and applied it to real life heating.For high-space factory buildings and industrial buildings, using hot water infrared radiation panel is an effective way of heating, can meet the requirements of use.


	 


	 


	Hot water infrared radiation panel heating is similar to the sun, sunlight shines on the Earth's surface, the surface temperature increases, and then indirectly heating the air layer.Eighty percent of the heating capacity of the radiant panel comes from this thermal radiation.Since air absorbs almost no radiant heat, radiant heat directly heats the surface it hits, such as the ground, objects, and people beneath it, and then releases heat into the surrounding air.The irradiated surface can be as much as 3 ° C warmer than the ambient air temperature.The panels themselves also heat the surrounding air by convection, which accounts for a very small proportion of the heat.Hot water infrared radiation board of heat radiation, comfortable and uniform, no fan, no air convection, no wind no dust, is a very comfortable heating method for human body.


	 


	<img src="http://www.wmkan.com/Uploads/image/20230519/20230519144446_42961.png" alt="" /> 


	 


	ECOPAN hot water radiant panels are prefabricated at the factory in standard lengths of 3 meters, 6 meters (2 meters, 4 meters for special requirements).Each radiant panel can be connected by quick joint or welding.Each panel and collector is prefabricated and safety tested at the plant.The support of the suspension plate is welded together with the radiant plate, one per meter, greatly ensuring the flexibility of installation.


	 


	The ECOPAN Hot Water radiant panel uses an innovative design concept. The pipe, as the warmest part of the panel, is completely downward, and 70% of its surface is covered by a metal plate (covering an Angle of more than 280°), which increases the heat transfer area and ensures excellent heat transfer from the tube to the plate.