麻豆久久久久精品,91色片,有色金属价格行情

Large space using hot water radiation panel is efficient and stable, saving cost

time：2023-11-28
hits：1501次
source：正弘奧能

At present, convective heating system is widely used in industrial plants in China. The cooling equipment heats the air in the surrounding environment, and then uses the specific gravity characteristics of hot and cold air to exchange heat, so as to achieve the purpose of improving the entire ambient temperature. However, the heating effect of this way is affected by the spatial form of the building structure, insulation performance and other parameters, and the heating heat load is relatively unstable. 
 

	In some high-end industrial plants, the requirements for heating conditions are high, and the airflow speed caused by heating should not be too large. In the convective heating process, cold and hot air has been circulating, which will affect the comfort of the human body, in contrast, radiation heating basically does not cause air flow, and the heat loss is small, and the building envelope can only absorb heat from the indoor air and dissipate heat to the outdoor through its surface.


	 


	<img src="http://www.wmkan.com/Uploads/image/20231128/20231128112105_48353.jpg" alt="" /> 

 
The hot water radiant panel is a kind of metal radiant panel, which can be used for comprehensive heating of buildings with a height of 3m~30m and local area or local working place heating, which is not only efficient and energy-saving, but also has the characteristics of green environmental protection, space saving and high comfort, and its use is very wide. Under the same conditions, the air temperature of radiant heating is very low, usually 2-3 ° C, so the temperature difference between indoor and outdoor is small, so the heat loss of the building is relatively low. The heat consumed by radiant heating is relatively low compared with convective heating, which is about 0.8 times that of convective heating, that is, the heat consumption of radiant heating is about 30% of that of convective heating. Radiant heating can save 30-50% more energy than convection heating. 
 

	ECOPAN hot water radiation board promoted and sold by Beijing Leadway Power Co., Ltd. adopts an innovative design concept. The radiation board is made of metal plate. On the shell of the steel plate, 2/3 of the surface is wrapped with a diameter of 1/2 "or 3/4" electric welded or non-welded steel pipe. The pipe, as the warmest part of the panel, is completely downward, and 70% of its surface is wrapped by a metal plate (wrapping Angle of more than 280°), which increases the heat transfer area, perfectly ensures the transfer of heat from the tube to the plate, and reduces the convective flow. Increase radiation, very suitable for aircraft and automobile maintenance halls, building materials markets, shopping centers, exhibition venues, multi-functional stadiums and entertainment halls and other tall space occasions.


	 


	<img src="/Uploads/image/20231128/20231128112130_60119.jpg" alt="" />

 
In fact, the initial installation fee of the ceiling hot water radiation panel is not higher than the current traditional heating cost, especially to the later operation, and its energy-saving characteristics mean that energy consumption and economic costs are saved. Hot water radiation panel does not require any special maintenance, no moving mechanical parts, no need to set up a special post to manage and maintain, you can save some labor costs.