99久久精品久久,毛片网站观看

Will the use of hot water radiant panels in tall Spaces increase the fire rating of buildings?

time：2023-08-04
hits：1853次
source：正弘奧能

In a large-space building, the roof is the largest surface and is the place where the most heat is dissipated.Unlike traditional convection heating methods, hot water radiant panel heating allows direct heating of people and objects in tall space areas without heating the entire indoor temperature, and has very low air stratification.Heat is not wasted heating parts of the building that are not being used, and the result is considerable energy savings.In the case of meeting the same heating effect, the energy saving of the hot water radiation panel can reach 30-50%.


	 


	So, the use of hot water radiant panels for heating in tall space buildings will increase the fire risk level of the building?


	 


	The answer is: No!


	 


	The hot water radiant panel system uses hot water as the medium, there is no risk of fire, and there are no combustible components.It can be used in volatile and flammable built environments without the risk of fire and explosion.


	 


	Hot water radiant panels are the most suitable solution for heating industrial buildings with wood processing.Radiant heating provides the necessary comfort without air or dust moving around, and responds almost immediately to temperature changes in the room, which can occur due to the switching of the system and the heat load associated with the operation itself in the room.There are many important practical applications in the wood and furniture industry, from sawmills to large processing plants to storage warehouses, where hot water radiant panels can be used for heating.


	 


	<img src="http://www.wmkan.com/Uploads/image/20230804/20230804112958_76041.png" alt="" /> 


	<img src="http://www.wmkan.com/Uploads/image/20230804/20230804113010_70647.png" alt="" /> 


	 


	ECOPAN hot water radiation board promoted and sold by Beijing Leadway Power&nbsp;Co., Ltd. adopts an innovative design concept, the main features of ECOPAN are: The radiation board is made of cold-formed pressed steel plate, on the shell of the steel plate, with a diameter of 1/2 "or 3/4" electric welded or non-welded steel pipe wrapped 2/3 of its surface.Special attention is paid to the expansion between the pipe and the plate, as well as technical solutions that make installation easier and ensure safety.


	 


	As the warmest part of the panel, the pipe is completely downward, and 70% of its surface is wrapped by the metal plate (the wrapping Angle is more than 280°), which increases the heat transfer area, and perfectly ensures the transfer of heat from the tube to the plate, reducing the convective flow and increasing the radiation.